1. Cut ERFURT-FlexoMur with additive, and roll up with underside outwards.

2a. The application of the adhesive is carried out directly onto the facade surface using a colour roller in fabric width + 10 cm addition.

2b. Subsequently, remove adhesive crossways to the direction of running using the toothed spatula (size C3, B2 or G).

3. Lay the wall covering into the moist ERFURT-FlexoCol with butt joint and using wall-adhesion technique. Press down using the rubber roller and/or a synthetic spatula.

4. Remove excess adhesive immediately and thoroughly. To clean up use brush, sponge, lambskin roller or similar.

5. In the event of interruptions in hanging, remove the adhesive applied over and beyond the width of fabric using the spatula. It is a good idea to work roughly 5 cm inside the seam so that it is not necessary to apply adhesive exactly to the edge of the fabric width.

6. Proceed in the same way with long lengths of fabric stuck vertically. When changing the stand position, remove superfluous adhesive. Fix width at the height of the stand position, e.g. with clamps.

7. Never stick around a corner. Always trim at corners.

8. To ensure a perfect finish, we recommend the fabric-finishing rails and corner-protection rails from the ERFURT range.

9. If no finish, base or similar is provided by the customer, one can be created using the ERFURT finishing rail.

10. Paint over ERFURT-FlexoMur twice using weather-resistant latex paint. In the event of large cracks of group B + C, paint over with elastic paints.